home *** CD-ROM | disk | FTP | other *** search
/ Magnum One / Magnum One (Mid-American Digital) (Disc Manufacturing).iso / d21 / qwhite10.arc / PS2.TEC < prev    next >
Text File  |  1990-08-16  |  2KB  |  52 lines

  1. ID:P2 Considerations on PS/2 Machines
  2. DESQview/QEMM Technical Note
  3.  
  4.  
  5. Note:  These comments are specific to IBM Models 50, 50Z, 55SX, 
  6. 60, 70 and 80 and compatibles that have the "Microchannel" 
  7. motherboard.  They do not apply to AT's, PC's, XT's, or 
  8. compatibles or PS/2 Models 25, 30 or 30-286 which use standard 
  9. architecture.
  10.  
  11. For the most part, if you are running DESQview or QEMM 
  12. (Quarterdeck Expanded Memory Manager 386) on PS/2 machines, you 
  13. follow the same rules set forth in the DESQview manual for 
  14. running on machines with the standard architecture, however there 
  15. are a few areas where setup for these machines differ.
  16.  
  17. 1.  Optimize Communications:  Microchannel machines have a 
  18. different interrupt structure than standard architecture 
  19. machines.  If you are running a version of DESQview prior to 
  20. 2.23, when configuring the DESQview Setup program (under 
  21. Performance), you should always be sure the option "Optimize 
  22. Communications" is set to "N".  Setting this option to "Y" 
  23. will result in errors reading your floppy drives.  Versions of 
  24. DESQview after 2.23 handle this difference in interrupt structure 
  25. and allow you to set the option to "Y" for microchannel machines.
  26.  
  27. 2.  IBM Cache:  The IBM Cache uses exTENDed memory (not exPANDed) 
  28. and if loaded after our Expanded memory manager (QEMM), will not 
  29. see any memory if you have not taken steps to reserve some 
  30. extended memory for the use of the cache.
  31.  
  32. If you load the cache first, it will see and use extended memory, 
  33. but if QEMM is loaded after it, the cache is confused by the 
  34. memory mapping done by QEMM and this will result in disk errors.  
  35. Therefore, you should be sure you are loading IBMCACHE after 
  36. QEMM.SYS.
  37.  
  38. If you are using the IBM Cache on a 386 PS/2 with QEMM, load QEMM 
  39. first and use the "EXTMEM" or "MEMORY" option to reserve the 
  40. amount of memory you want to allocate to the cache.  Then load 
  41. the cache, allocating to it the amount of memory you have 
  42. reserved.  Loaded in this fashion, the cache should operate 
  43. properly.
  44.  
  45. This configuration should also be followed if loading other 
  46. caches that use extended memory on the PS/2.  Naturally, if you 
  47. use a cache that uses exPANDed memory, you would have to load the 
  48. cache after QEMM and you would not need to reserve any exTENDed 
  49. memory.
  50.         Copyright (C) 1990 by Quarterdeck Office Systems
  51.              * * *   E N D   O F   F I L E    * * * 
  52.